Industrial Joystick

[Dinosaur]

Hi all

I have an analogue Industrial Joystick (Penny & Giles JC2000) which has a single Thumb button.
To interface this to XPe I have purchased a Game Port to USb converter.(RockFire RM-203).
Connecting this and trying to calibrate it (with GameController/Properties) results in movement
from Centre to two sides only. I have tried a number of Joystick to Mouse converter programs,
but they all do the same. The output on X & Y from the Joystick is 2.5vdc when centred and goes up or down
depending on the direction you move it on both X & Y axis. I am sure it is connected correctly to
the Game Port plug.

Is this a converter problem, or will Xpadder solve this problem ?
I simply need this joystick to act like a mouse for my applications.

Regards

[SGTCableDog]

If this controller setup appears in Windows Game controllers control panel correctly (test tab shows proper movement) then you can use Xpadder to assign mouse movement (and more) to the stick.

[Dinosaur]

Hi all

The only movement shown is when I move the stick to 6 o'clock or 3 o'clock.
Movement to 9 o'clock and 12 o'clock gives no response.
So I guess it doesn't show proper movement.

Thanks for your hep anyway.

Regards